34
Assembly
Electrical installation
13
Install the PCB assembly and associated wiring in the mechanism housing as follows
13.1 Install dowel pin (12) in mechanism housing (1).
13.2 Install push-button cap (7) and ‘O’ ring (8) on PCB (2).
13.3 Using Silcoset 153, position PCB in mechanism housing (1). Secure with screw (9).
13.4 Temporarily install mechanism housing cover (5), ensuring push-button cap (7) is correctly
located. Allow Silcoset 153 to cure fully, then remove mechanism housing cover.
13.5 Install wiring in appropriate channels in the mechanism housing (1) and secure with Silastic RTV
adhesive. Allow Silastic to cure fully.
Outrigger and tilt drag
14
If removed, install wiring and LED lens as follows
:
14.1 Install wiring so that LED is correctly positioned in relation to LED lens (6).
14.2 Secure LED lens (6) in outrigger (18) using Loctite 406.
14.3 Install wiring in appropriate channels in the outrigger (18) and secure with Silastic RTV adhesive.
Allow Silastic to cure fully.
15
Referring to
, lubricate the gear on the tilt drive shaft (5) with Easyrun grease and install in
outrigger (18). Secure with circlip (4).
16
Install the pan brake components in the outrigger as follows
16.1 Install the brake wedges (6) in the calliper (5).
16.2 Sparingly lubricate the thread on the shaft (2) using Castrol LM grease. Ensure grease does not
contact brake pad or wedges.
16.3 Install an ‘O’ ring (3) on shaft (2) and screw into calliper (5). Screw down lightly to hold wedges in
position.
16.4 Position calliper in outrigger (4). Do not fit the brake knob at this stage.
NOTE:
Do not secure the potentiometer to the mechanism housing at this stage.
NOTE:
The tilt brake and pan brake wedges are NOT interchangeable. Tilt brake wedges have a
flat face, pan brake wedges are radiused