32
6.6
If required, pull flanged bearing (10) out of mechanism housing (9).
6.7
If required, remove dowel pin (27) from pan module (26).
6.8
If required, remove three screws (19) securing stud carrier (24) to pan module (26). The stud (25)
is screwed into the stud carrier and is retained with Loctite 601.
Tilt drag mechanism
7
To remove the tilt drag assembly:
7.1
Remove the RH side plate, balance mechanism and pan drag mechanism.
7.2
, disconnect the wiring (11) between the mechanism housing (1) and the
outrigger (10).
7.3
, turn the tilt brake knob (17) and tilt drag knob (11) fully counter-clockwise.
7.4
Prise out the tilt drag knob plug (12), remove the screw (13) and washer (14) and pull off the drag
knob (11). Remove the drag knob boss (10), two steel balls (9) and springs (8).
7.5
Remove outrigger label (15).
7.6
, remove four screws (12),which secure the outrigger (19) to the mechanism
housing.
7.7
, turn the tilt unit (21) until the brake knob (17) aligns with the hole for slide
release button in the tilt module (1).
7.8
Remove two screws (7) and one screw (16) securing outrigger (21) to tilt module (1). Note length
and position of screws. Carefully pull the outrigger off the tilt module. Retain all shims (2).
7.9
Remove two Spirol pins (3).
, remove three screws (11) securing tilt module (9) in bearing (10). Pull tilt
module out off the bearing.
7.11 If required, remove three screws (11) securing bearing (10) in mechanism housing cover (17).
The bearing is retained with Loctite 641.
WARNING!: Do not attempt further dismantling of the pan drag module. A faulty assem-
bly must be replaced.
WARNING!: Do not attempt further dismantling of the tilt drag module. A faulty assem-
bly must be replaced.