Vinteck
V-10 CLIPPER
pag.14
Edizione 01 revisione0
PROGRAM CHANGE MIDI MAPPING
.
Sofware release DCEA
It is possible to assign a PROGRAM CHANGE differento from patch number.
Default is program change = patch number.
To change program change:
While on the patch (ex 003, anyway 1 to 120) with white led “P” on :
Hold pressed MD for 3 secs
Display show : 001 PC : 000
Use UP and DW (down) to select desiderate Program change number
Selection is done.
Save and exit with MD
Note: when recalled a preset whit Control Change chained, the orange led will blink to show that
Control change are active and send.
PROGRAM CHANGE MIDI MAPPING. – ASSIGN OF 1, 2 or 3 PROGRAM CHANGE
Firmware release SW 0682
It is possible to assign up to 3 different POGRAM CHANGE on different CHANNELS for any single
program / patch , from 1 to 100
As default any program/patch got corrisponding PROGRAM CHANGE (1 = 1, 2= 2 etc)) and send
only 1 PC.
To set up PC anch channels:
Recall the program to modify (1 -100)
With white led “P” on, press MD ank keep pressed for 3 seconds.
Display show: 001 P1 : 001 (001-> patch P1-> progarm : 001 the number of CC)
With UP or DW it’s possible to change the PC from 1 to 128
Pressing pulsant “5” display show 001 CH1 : 01
Pressing UP or DW is possible to change the channel, from 1 to 16
Then:
pressing pulsant 2
display show 001 P2 : 000
with UP and DW is possible select from 1 to 128. 000 means NO PC
Press pulsant “6” display show 002 CH1 : 01
With UP and DW is possible to slect from 1 to 16
Then:
pressing pulsant 3
display show 001 P3 : 000
with UP and DW is possible select from 1 to 128. 000 means NO PC
Press pulsant “7” display show 003 CH1 : 01
With UP and DW is possible to slect from 1 to 16
Exit and save with MD
