Vintec AL-V40BVC, User Manual

Page: 14 / 20

V20BVCBK 14
User Manual
5. This Vintec Beverage Center is front venting. The cabinet draws air from the front
and rear and expels through the grill under the door at the front. If a joinery kick
board is being placed in front of the Beverage Center, a grill of at least the same
width as the Beverage Center grill and with a minimum airflow allowance of
150cm2 must be installed into the kick board.
6. This unit has a power switch located on the control panel. Power point location is
therefore not critical.
7. This unit requires a standard 240 volt/10 amp power point.
8. The power cord is 1.9m in length and is affixed to the right side at the back of the
cabinet.
9. As with most appliances of today, this cabinet has sensitive electronic components
which are susceptible to damage by lightning and electricity supply faults. It is
therefore advisable to use a power surge protector to avoid problems of this nature.
10. Please see detailed dimensional diagrams in the preceding pages. Please note: The
preceding diagram is for the 85mm plinth recess models.
Further Instructions:
The location you have selected for your Beverage Centre should:
- be unencumbered and well ventilated;
- be well away from any heat source and direct sunlight;
- not be too damp (laundry, pantry, bathroom etc.);
- have a flat floor;
- have a standard and reliable electricity supply (standard socket to country standards,
linked to the ground). It is NOT recommended to use a multi-socket or extension lead;
- have a surge protector fitted to the electrical outlet;
- be away from the microwave;
Note: Certain microwave ovens do not have wave interference shield. When placed within
a 1 meter vicinity of the Beverage Center, they may affect the operation of the wine
cabinet.
- do not cover the glass door with any other kind of door - this unit CANNOT be
integrated behind joinery
Notes: Not complying with any of the above instructions may result in WARRANTY void.