Vintec AL-V40BVC, User Manual

Page: 12 / 20

V20BVCBK 12
User Manual
If it is left hinge,reverse the door as the same way.
V40/V26/V20 SERIES
UNDER-BENCH INSTALLATION INSTRUCTIONS
1. Vintec beverage Center dimensions:
V40
Height 820mm – 860mm (40mm adjustable feet)
Width 595mm
Depth 571mm + 30mm stopper (Total of 601mm)
V26
Height 820mm – 830mm (10mm adjustable feet)
Width 380mm
Depth 572mm + 30mm stopper (Total of 602mm)
V20
Height 810mm – 830mm (10mm adjustable feet)
Width 295 – 300mm
Depth 561– 592mm + 30mm stopper (Total of 622mm)
2. This Vintec Beverage Center is not designed to be fully integrated behind a joinery
door.
3. Please note that:
For V40 a minimum cut out width of 615mm is required to facilitate installation,
removal and servicing.
For V26 a minimum cut out width of 400mm is required to facilitate installation,
removal and servicing.
For V20 a minimum cut out width of 320mm is required to facilitate installation,
removal and servicing.
4.
To provide good performance this cabinet requires adequate ventilation. The Vintec
Beverage Center cabinet requires 10mm clearance on both sides, on top; and 30mm
clearance at the rear. (You must fit the back spacer provided, it will ensure the
minimum 30mm clearance at the rear). A ventilation grid needs to be installed in
this 30mm clearance area at the rear. For good ventilation, it is necessary to install a
grill with a minimum size of 200x40mm at the top of the back wall or on either side
at the top rear – refer to diagrams on the following pages. This is to allow cooler
fresh air to flow into the 30mm gap at the rear of the cabinet. The ventilation grill
must not be installed close to an oven or next to a sealed area without access to
fresh cool air. (Do call Vintec’s Service Department for further explanation. Failure
to comply with the above specifications could void the WARRANTY.)
4. Remove decorative nail (8) from left top of cabinet and install spare top hinge (Left) (7)
at left top of cabinet with 3 screws. (Fig. D)
5. Following the above procedure, install the spare lower hinge to the left (9). (Fig. E)
6. Install and aligned the door.
7. Insert the plastic caps to cover the holes(8).
V20BVCBK
1 Lock screws 2 Lower hinge (Right) 3 Door axis
4 Top hinge (Right) 5 Door 6 Cabinet body
7 Top hinge (Left) 8 Lower hinge (Left)
- Unscrew the lock screws (1); (Fig. 1) to remove the door axis located at the bottom.
- While holding the door firmly, pull the door (5) outward and take it out; (Fig. 2)
- Remove the 3 bolts and take out the right top hinge (2); (Fig. 3)
- Fix the left top hinge and the bottom left hinge with the bolts as per Fig. 4,
- Re-install the door the same way it was removed and fix back the door axis.