INSTALLATION INSTRUCTIONS
Location Requirements
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc). This unit is intended for indoor, household use only. Do not install
the unit in moist areas.
•
Do not install the unit where the ambient temperature range will be below 55°F or
above 90°F. As the compressor will not be able to maintain the proper
temperature.
•
Unit is not intended for garage or basement installation. Place the unit out of
direct sunlight.
•
For best performance, it is recommended to install the unit where the
temperature is between 72-78°F. Otherwise, the unit may run longer at low
efficiency.
•
The unit must be placed in a properly ventilated location to prevent heat build-up
generated by the refrigeration system. Failure to do so will prevent the unit from
cooling properly, and may result in damage to unit components as well as its
contents.
•
The unit must be installed on a floor that is level and strong enough to support a
fully loaded unit up to 500 lbs.
Installation Requirements
CAUTION:
Do not block the front grille on the lower front of the unit.
•
This unit is designed for free-standing installation, but it can also be recessed in a
space between cabinets and enclosures that
allows 1/2” clearance at the top, 1” clearance
behind the unit if the electrical outlet is recessed
or 1 1/2" to 3” if surface mounted.
•
Allow minimum 2 1/2" clearance between each
side of the unit and an oven/range to keep away
from direct heat source.
•
Adjust the leveling legs to level the unit at a
height that allows the door to be closed properly.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
11
Summary of Contents for VT-100 WINEDISP4
Page 30: ...W W W V I N O T E M P C O M 30...
