28
7602050
FIG.45
FIG.46
FIG.48
FIG.49
FIG.50
FIG.47
6.16-
Drive the stairlift to the top of the track. If the
footplate does NOT finish level with the landing then:
a:
Drive the stairlift so that the footplate is level with the
top of the stairs as shown in (Fig. 49).
b:
Measure the distance from the top safety edge to
the inside face of the end cap as shown in (Fig. 50).
c:
Drive the stairlift halfway down the stairs.
d:
Carefully slide the top of the track into the middle
of the staircase so that you have access to the limit
switches (you may not need to do this if you are instal-
ling a left hand lift).
e:
Loosen the grub screws on the limit switch (the top
one) so that you can just slide it.
NOTE:
Be careful not to loosen the grub screws fully
– the limit switch may slide all the way down the track.
f-
Slide the limit switch down the track so that the distan-
ce from the top edge of the stop to the inside face of
the end cap is the same as the distance measured from
the safety edge to the end cap as shown in (Fig. 51).
g-
Tighten the grub screws.
h-
Re-position the track in its final location as previously
described.
i-
Drive the stairlift back to the top of the stairs and check
that the footplate now finishes level with the landing as
shown in (Fig. 49).
j-
Make minor adjustments as necessary and repeat
process until the footplate finishes level with the landing.
6.17-
Secure the feet to the staircase using the wood-
screws provided as shown in (Fig. 52).