4
General description - Characteristics - Connections
1. General description
Electronic control with 6 independent pushbuttons, 8 non-polarised inputs, 7 solid state outputs for non-polarised contacts, configurable RGB LED backlighting, 9-32 Vdc
power supply, to be completed with Eikon Tactil labels and cover plate - 3 modules.
2. Characteristics
• Supply voltage: 9-32 Vdc SELV (insulated with double insulation on the power supply network)
• Max absorbed power in power supply input: 0.7 W
•
Inputs:
- Input activation voltage: 5-32 Vdc
- Input activation current: 0.7-5.5 mA (according to input supply voltage)
- Signal frequency PWM input 7: 400 kHz (if you wish to change the current colour settings of the LEDs)
•
Outputs:
- Voltage that can be controlled by the outputs: 40 V
- Current that can be controlled by each individual output: 100 mA
3. Connections
N.B. The conductors of the inputs and outputs can be extended up to at most 50 m (minimum section 0.33 mm
2
).
3.1 Inputs
The inputs connector is of the type JST PHDR-12VS.
30 cm
These are live inputs (they can be controlled directly using the supply voltage) and are all referred to the common contact of pin 11.
The inputs are non-polarised and can be activated with positive or negative currents, and therefore by push-pull, open collector, open-emitter or voltage-free contacts.
FRONT AND BACK VIEW
Configuration
buttons
Power supply
- +
Connector
inputs
Connector
outputs
9-32V
100mA
INPUTS
I2
I4
I6
I8
NC
NC
I1
I3
I5
I7
NC
C IN
O1
O2
O3
O4
O5
O6
NC
O7
C OUT
OUTPUTS
