25
6.5 IP Firmware Update
Under the Update tab the 01548 firmware can be updated via IP i .e . the Ethernet network . The complete remote update process is described in following steps . During
this process, 01548 enters its boot mode . Then LEDs 1, 2, 3 and 7 light as described in Table 5: LED Status Display for Firmware Update .
If boot mode is already active only the web front-end instructions from step 3 to step 5 must be followed (refresh, request update) .
To exit the boot mode, it is necessary to enter the Update tab of the web front-end . Then, either the firmware update has to be completed (like shown by steps 1 to 5) or
the firmware update process has to be stopped by a click on the “Abort” button (see step 5, Figure 27) . After that, 01548 restarts and continues with normal operation .
Step 1: Open the Update tab of the web front-end.
Figure 23: Update Tab
Step 2: Activate Programming Mode (KNX tab or Programming Button).
Figure 24: Update Tab and activated Programming Mode
Step 3: After Programming Mode activation, give a short press to the Function Button. Then click on the “refresh” button.
Figure 25: Update Authorized
Web Front-end