Villaware BVVLESSL01, Instruction Manual

Page: 11 / 76

10
3. Allow appliance to sit overnight with the vinegar solution in the water reservoir.
4. Discard vinegar by removing the reservoir and turning it upside down over the sink.
5. Rinse the water reservoir thoroughly with tap water by filling tank half full with water and
then pouring the water back out into the sink, repeating this step twice.
TO DESCALE INTERNAL PARTS:
1 . Make sure you descale the inside of the water reservoir first by following the “Descaling”
steps above.
2. Make sure all controls are in the off position and the power cord is disconnected from
the electrical outlet. Fill the reservoir with white vinegar above the minimum level.
3. Insert the portafilter with filter into the PortaSlide System. Place a jar on top of the drip
grill and under the portafilter.
4. Plug the power cord into the electrical outlet.
5. Press the power button to turn the unit on. The light ring will flash until the brewing
temperature is reached and then it will be steady on. Turn the espresso brewing dial to
cleaning cycle mode and then press the brewing start button. The cycle will automatically
stop and the amber light will turn off.
6. To clean the steam wand internally, place a cup with cold water under the tip of the
steam wand. Insert the steam wand into the water and press the steam start button “
+
”.
Turn the dial to release steam. Let the steam come out for a few minutes before pressing
the steam button “
+
” to stop the steam cycle. This will clean any residue left in the
steam wand. Repeat the process as needed.
7. Repeat steps 1 – 6 as necessary using only tap water to rinse any remaining traces of
vinegar out of the machine.
storing
Store your espresso maker on top of your kitchen countertop or inside a cabinet. Ensure to
unplug the unit if not in use.
Do not store the unit with the locking lever in the locked “ + ” position.
Do not store the unit with water in the water reservoir.
cleaning
(continued)