Villager VLP 5320, Original Instruction Manual, Page: 30 / 136

13
Maintenance
Remove the battery from the power tool before carrying out work on the power tool (e.g.
maintenance, changing tool, etc.). The battery should also be removed for transport and
storage. There is risk of injury from unintentionally pressing the on/off switch.
General
Cleaning and correct maintenance of the tool is important for both safety and for the
service life of the tool.
NOTE: Switch off the tool and disconnect it from the power supply (remove the
battery/unplug the power cord) before cleaning and maintenance - risk of electrical shock
and accidental starting.
•
Wipe the tool with a cloth moistened with water and a few drops of soap or detergent.
Brush clean hard to reach areas with a brush. NOTE: Do not use cleaning agents that
contain solvents or abrasive or corrosive additives - risk of damaging tool surfaces.
•
Clear the tool vents and the accessory mount after each use of with brush and cloth.
•
Stubborn contamination in areas hard to access can be removed with compressed air.
•
Always check after each use that any accessories are free from damage.
•
Remove the accessory from the tool’s drive after each us e and clean the drive.
WARNING: Brake fluid, petrol, mineral oil and petroleum products must not come into
contact with the plastic parts of the power tool. This type of product can damage or
deform the plastic.
•
WARNING: Always wear safety goggles that seal against the face and also protect
from the side when using compressed air to blow clean the power tool. When
performing very dusty work, a dust mask should also be worn.
Transport & Storage
•
Clean the tool as instructed and allow it to dry.
•
If the tool shall remain unused for any length of time, it should be stored in the originai
packaging.
•
Store the tool in a dry place, well ventilated and out of the reach of children.
Only store an appliance within a temperature range of 5 to 30 °C.
•
Always shut off the tool before transport.
•
Always carry the tool using the purpose-designed handle.
•
Ensure that the tool is not at risk of tipping over or exposed to vibration and shocks
during transport, especially if the tool will be transported by car or other vehicle.