Villager VLN SC 350, Original Instruction Manual

Page: 31 / 95

13
Figure 11
Figure 12
4.3 Replacing of the shearing blades
Operate only with sharp shearing blades. Replace the blunt blades or the ones missing
teeth.
4.4 Air filter cleaning
4.5 Storing of the device
At this point, it is important to lean the blades against each other in such
a way that the sharpened surface of the comb plate protrudes
approximately 1.5 to 2.0mm in relation to the upper blade tips (Figure
10).
When you adjust the shearing blades, place the comb plate and tighten
the blade screws.
Check if the shearing blades are properly installed and if the pressure
conical clamps are in the openings located on the clipping blade (Figure
3, Item 2). At this point, tighten the locknut until the clipping blade is
positioned tight to the comb plate and until you feel slight resistance.
Air filter is located on the bottom of the motor unit. Air filter may be
removed from the device for cleaning. It is essential to regularly clean
the air filter with dry brush.
Make sure no foreign objects penetrate the air filter while cleaning. The
device must never be operated without the air filter!
Store the device in dry place in original storing case. Do not turn on the
device if you suspect that liquids penetrated it. There is danger from
electrical shock or short circuit. Take the device to an authorized service
center.
Make sure to store the device between uses. Store the device clean,
lubricated and with loosen screws in a storing case and clean and dry
place, out of reach of children.