Villager VLN SC 350, Original Instruction Manual

Page: 23 / 95

5
e) Maintain power tools and accessories. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a
hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for safe handling and control of the tool in
unexpected situations.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
1.1 Appearance / controls
Elements
1.2 Use of the device
Sheep clipper is intended for use on sheep and goats only.
Other uses, especially on humans, are considered unauthorized.
1 Clipping blade 12 Rotor 23 Lever roller
2 Pressure clamp / Tab 13 Carbon brush spring 24 Lever shaft
3 Swiveling fork 14 ON/OFF switch 25 Motor
4 Tension spring 15 Technical plate 26 Air filter
5 Cap 16 Anti-kink sleeve 27 Blade tightening screw
6 Adjusting knob 17 Cable 28 Bearing
7 Locknut 18 Conical bracket pins
29 Speed selection
thumbwheel
8 Gear 19 Comb plate
9 Reduction gear 20 Safety extension
10 Motor bearing 21 Shearing head
11 Stator 22 Spring
Figure 1