Villager VGS 380 PRIME, Original Owner'S Manual, Page: 55 / 157

Villager VGS 380 PRIME (GB)
25
Fuel filter
4. Others
Check for fuel leakage and loose fastenings and damage to major parts, especially handle
joints and guide bar mounting. If any defects are found, make sure to have them repaired
before operating the saw again.
 PERIODICAL SERVICE POINTS
1. Cylinder fins
Dust clogging between the cylinder fins will cause overheating of the engine. Periodically
check and clean the cylinder fins after removing the air cleaner and the cylinder cover.
When installing the cylinder cover, make sure that switch wires and grommets are
positions correctly in place.
2. Fuel filter
(a) Using a wire hook, take out the filter from the filler port.
(b) Disassemble the filter and with gasoline, or replace with a new one if needed.
Note: Be sure lo block the air intake hole
.
Note:
• After removing the filter, use a pinch to hold the end ol the suction pipe.
• When assembling the filter, take care not to allow filter fibers or dust inside the
suction pipe.