Villager
VGS 380 PRIME (GB)
16
Chain oil
L needle
H needle
Idle adjusting
screw
CHECKING THE OIL SUPPLY
After starting the engine,run the chain at medium speed and see if chain oil is scattered
off as shown in the figure.
ADJUSTING THE CARBURETOR
The carburetor on your unit has been factory adjusted, but may require fine tuning due
to a change in operating conditions. Before adjusting the carburetor, make sure that the
provided air/fuel filters are clean and fresh and the fuel properly mixed.
When adjusting, take the following steps:
1.
Stop engine and screw in both the H and L needles until they stop. Never force them.
Then set them back the initial number of turn as shown below.
H needle 3/4 ± 3/8
L needle 1,5 ± 1/4
2.
Start the engine and allow it to warm up at half-throttle.
3.
Turn the L needle slowly clockwise to find a position where idling speed is maximum,
then set the needle back a quarter (1/4) turn counterclockwise.
4.
Turn the idle adjusting screw (T) counterclockwise so that the saw chain does not turn.
Note: Be sure to adjust the carburetor with the bar chain attached.
Summary of Contents for VGS 380 PRIME
