Villager V 722, Original Instruction Manual, Page: 47 / 193

16
Villager V 722 (GB)
2.6 Required torque

Cutting housing shaft nut: 66± 13 ft-lb (90±18 N·m)

Engine housing/front frame mounting bolts: 40-52ft-lb (55-70 N·m)
3 ASSEMBLY INSTRUCTIONS
3.1 Unpacking
Open the box Remove the free parts (e.g. Manual, etc.) from the box. Remove the
device from the box. Make sure that some free parts are not left behind.
3.2 Assembly instructions

Extend (open) the handles - as shown in Figure 4.

Insert the threaded part of the connector of the end of the left and right
assembly lever of the control connecting rod through the openings of the left
and right oscillating brake shoulder. Add nut M6 and washer 8 and tighten.
Then insert the threaded part of the connector of the end of the gearbox lever
assembly through the shoulder of the gear shift. Add nut M6 and washer 6 and
tighten. To complete, add the threaded part of the connector of the end of rod
assembly of the blade control through the hole of the tightened oscillating
shoulder. Add nut M6 and washer 6 and tighten. See Figure 4.

The accelerator cable must be connected to the engine in accordance with the
instructions for the use of engine. Fuel tank line connected to the engine line.
(The positions of fuel filter and accelerator cable connector differ considerably
on different engine models). See Figure 5.