Villager SSV 7050 RS, Manual, Page: 48 / 252

20
Flexible shaft, Fig. 12-14
• Remove protective cap (O) from the threaded bushing (Fig. 13).
• Place flexible shaft onto the threaded bushing (Fig. 14).
•
Clamp tool in the drill chuck.
•
Firmly hold threaded shaft at the handle and switch on the speed control.
• Having finished the work, remove the flexible shaft and place the protective cap in
place. Attention: When working with the flexible shaft, cover the saw blade with the
blade guard.
WARNING! When the flexible shaft is not used, please make sure that the flexible
shaft is removed and the protective cap and blade guard are in place before starting the
machine.
Foot switch / continuous operation (Fig. 1+15+16)
The machine can be operated in continuous operation or with the additional foot switch
(11). The switch (12) is used to select between the operating modes. The operating mode
should always be selected when the machine is switched off.
The machine is in the foot switch mode when the switch is at the „0“ position .
The machine is in the continuous mode when the switch is at the “I“ position .
Attention! The machine may start due to unintentional actuation of the foot switch in the
foot switch mode.
Attention! Never leave the machine unattended while it is switched on.
Switching on/off (Fig. 1+15)
It is possible to switch the saw on by pressing the green „I“ button (6).
In order to switch the saw off again, it is necessary to press the red „0“ button (6).
The red warning light (a) indicates whether the machine is switched on or off. The machine
is switched on when this lights up. (The machine only starts up in the foot switch mode
once the pedal is actuated, the red warning light illuminates anyway).
You can only switch between foot switch and continuous operation when the red warning
light is not illuminated. If necessary, switch machine off first by pressing the red bu
tton “0”
(6).
Make sure you are aware of what operating mode (pedal/continuous operation) your
machine is in before switching it on.
Beware of unintentional actuation of the foot switch. Set the pedal (11) on the ground. The
machine can be switched on/off in pedal mode when the pedal is actuated. A foot switch
for switching on/off is practical, especially for internal cuttings, since your hands are kept
free and you can fully concentrate on the work piece under the scroll saw. However, it
cannot influence the speed.