A drain pump can be used to drain water when gravity drain is not available. Refer to
OWNER’S MANUAL for drain pump installation instructions (also supplied with drain
pump).
As with the gravity drain, it may be necessary to wrap the drain tubing for the icemaker
to the inlet of the drain pump with wrap type insulation.
Condensation can form on the
drain tubing and cause water damage.
1.11 OPERATION, SELECTOR SWITCH IS IN THE “ON” POSITION.
The assumptions before proceeding are that water is supplied to the icemaker (see page
#7), there is proper electrical power to the icemaker (see page #7), and the drain is
properly plumbed or the drain is operating properly.
Input power must be applied at all times for proper operation. Any interrupt will lockout
the compressor for up to 9 minutes and restart the mode of operation. The figure below is
the timing diagram / operation for the electronic control.
Figure 1.3
9
