Viking V36CO Series, Installation, Operation & Owners Manual

Page: 6 / 40

©2009 Viking Commercial Division
6
Riser Support Bolts
Riser Installation
1) Remove back panel from riser assembly by removing mounting screws
2) Remove the four bolts at the rear of the range top / work top holding on the side panels
(two on each side, see diagram below)
3) Place riser on support brackets on back of oven, cabinet or refrigeration base
4) Reinstall the four bolts into the back of the range top / work top through the riser
channels, do not tighten
5) Attach the bottom supports with supplied bolts, two on each side
6) Tighten the four bolts that attach riser to range top / work top
7) Tighten the four bolts that attach riser to bottom supports
8) Reinstall back cover
Note:
Failure to reinstall back cover could cause improper venting of exhaust gases from oven and
range tops creating soot to clog burner(s) and flue
Model / Serial / Rating Plate Locations
Oven, All
Behind kick plate on rail, right side
Range tops, Sealed Top Burner, French Top, Hot Top, Griddles (all), and Broiler
On front panel, left side above knob
Range Top Bolts