Disassembly
26
©2012 Viking Preferred Service
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Outer Door Panel Assembly Removal
1. Remove oven door (see Door Assembly Removal).
2. Place the door, handle side down, on a protected
surface.
3. Remove screws that attach the outer door panel
assembly to the inner door panel assembly.
4. Lift the inner door panel assembly from the outer
door panel assembly.
5. Reverse procedure for installation.
Door Handle Removal
1. Remove outer door panel assembly (see Outer Door
Panel Assembly Removal).
2. Remove screws and handle assembly from outer
door panel assembly.
3. Remove screws and slide end caps from handle.
Note:
View set screw markings thru end cap holes,
then install set screws.
4. Reverse procedure for installation.
Inner Door Glass Removal
1. Remove outer door panel assembly (see Outer Door
2. Remove screws and door insulation retainer from
door glass bracket holders.
3. Remove screws and door glass bracket holder from
inner door panel.
4. Remove inner door glass from inner door panel.
5. Remove black fiberglass rope from inner door panel.
Note:
Use care with insulation, make sure to replace
any damaged or missing insulation. Keep vent
on inner door panel clear of insulation.
6. Reverse procedure for installation.