Viking Designer DEDO530T, Service Manual

Page: 7 / 73

General information
© 2008 Viking Preferred Service
7
Control board headers
The T series wall ovens all use the same main control board. Each board is programmed to the
specific model by the use of a control board model select connector (Header). Each connector has
a color coded wire Molex plug which connects to the P9 connector of the main control board.
Fig A shows the different Molex header plugs along with the models that each goes with. Models
DEDO530T, VEDO530T and VESO530T DO NOT have a header plug. If you change the main
control board you must make sure that the header is removed from the old board and placed on
the new one. Failure to do so will cause improper operation of the oven. Fig B shows the location
of the control header.
Model - Serial number matrix
The model number and serial number are located on the data plate. The data plate is located on the top left
side of the oven cavity under the control panel.
Inner Bake Outer Bake Inner Broil Outer Broil Convection
Volts 240 240 240 240 240
Amps 6.25 6.25 10.60 6.00 12.50
Watts 1,500 1,500 2,550 1,450 3,000
Ohms 38.00 38.00 22.50 40.00 19.50
FIG A
FIG B
PE070763
White
PE070794
Blue
PE070795
Yellow
Models Models Models
DEDO 527T DESO 530T DEDO 130T
VEDO 527T DESO 527T VEDO 130T
VESO 527T
PE070796
Orange
PE070887
Red
Models Models
DEDO 127T DESO 130T
VEDO 127T DESO 127T
VESO 130T VESO 127T
The board shown here is
configured for a model
DEDO – VEDO 127T.