© 2010 Viking Preferred Service
13
Operation
Ice Maker and Ice Storage Bin
Alarm Sound
The ice maker and storage bin are located in the
upper left-hand side of the freezer compartment.
Turning the Ice Maker On/Off
The On/Off switch is located on the ice maker.
To turn on the ice maker, press the switch to the
“ON” position.
To manually turn off the ice maker, press the switch
to the “OFF”position.
Note:
Your ice maker has an automatic shutoff.
The ice maker sensors will automatically stop ice
production, but the control will remain in the
ON position.
Removing and Replacing Ice Storage Bin
To Remove the Ice Storage Bin:
1. Hold the base of the storage bin and press the
release button on the lower right.
2. Pull the storage bin out until resistance is felt.
Lift up the front of the ice bin and remove.
3. Press the switch to the “OFF” position.
To Replace the Ice Storage Bin:
IMPORTANT: It may be necessary to turn the auger
driver, behind the ice bin, counterclockwise to
properly align the ice bin with the auger driver. The
ice storage bin must be locked in place for proper
ice dispensing.
1. Press the switch to the
“ON” position.
2. Slide the ice bin into
the guide rails located
on either side of the
enclosure.
3. Push the ice bin in until
resistance is felt. Raise
the front slightly and push
the ice bin in until an
audible “click” is heard.
Ice Production Rate
UÊÊÊÊ ÊÜÊÓ{Ê ÕÀÃÊÌÊ«À`ÕViÊÌ iÊwÀÃÌÊL>ÌV ÊvÊVi°Ê
Discard the first three batches of ice produced.
UÊÊÊ Ê/ iÊViÊ>iÀÊÃ Õ`Ê«À`ÕViÊ>««ÀÝ>ÌiÞÊnÊ
to 12 batches of ice in a 24-hour period.
UÊÊÊ Ê/ÊVÀi>ÃiÊViÊ«À`ÕVÌ]ÊÜiÀÊÌ iÊvÀiiâiÀÊ
and refrigerator temperature. See “Using the
Controls.” Wait 24 hours between adjustments.
Remember
UÊÊÊ Ê/ iʵÕ>ÌÞÊvÊÞÕÀÊViÊÜÊLiÊÞÊ>ÃÊ}`Ê
as the quality of the water supplied to the
ice maker. AVOID connecting the ice maker
to a softened water supply. Water softener
chemicals (such as salt) can damage parts of
the ice maker and lead to poor quality ice. If a
softened water supply cannot be avoided, make
sure the water softener is operating properly
and is well maintained.
UÊÊ Ê"Ê "/ÊÕÃiÊ>ÞÌ }ÊÃ >À«ÊÌÊLÀi>ÊÕ«ÊÌ iÊViÊ
in the bin. This can cause damage to the ice bin
and dispenser mechanism.
UÊÊ Ê"Ê "/ÊÃÌÀiÊ>ÞÌ }ÊÊÌ«ÊvÊÌ iÊViÊ>iÀÊ
or in the ice storage bin.
Water and Ice Dispenser
IMPORTANT:
UÊÊÊ ÊvÌiÀÊViVÌ}ÊÌ iÊÀivÀ}iÀ>ÌÀÊÌÊ>ÊÜ>ÌiÀÊ
source, flush the water system. Press the
“WATER” touch pad on the control panel. Use
a sturdy container to depress and hold the
dispenser lever for five seconds, then release
it for five seconds. Repeat until water begins
to flow. Once water begins to flow, continue
depressing and releasing the dispenser lever
(five seconds on, five seconds off) for an
additional five minutes until a total of 4 gal.
(15L) has been dispensed. This will flush air
from the filter and water dispensing system.
Additional flushing may be required in some
households. As air is cleared from the system,
water may spurt out of the dispenser.
Note:
After five minutes of continuous dispensing,
the dispenser will stop dispensing water to avoid
flooding. To continue dispensing, remove the
container and press the dispensing lever again.
A.
ON position
B.
Auger driver
A
B
