14
E. Keyless Entry Codes and One Time Use Keyless Entry Codes
F. Operation Commands
Touch tone keyless entry codes may be used by the tenants to provide keyless entry. Each entry phone may
have up to 6 keyless entry codes. There are also up to 6 master keyless entry codes which can be used at all
four entry locations. If a keyless entry code has been programmed, an off-hook entry phone is given 4 seconds
of dial tone before ringing the house phone. During this time a touch tone “
#
” + the “
keyless entry code
” may
be entered.
A correct keyless entry code will provide a timed door strike activation for that entry phone location. One time use
keyless entry codes function as described above but can only be used
ONCE
. After the one time use keyless
entry code has been used, it is instantly cleared from the
C-2000B
’s memory. This is ideal for issuing keyless
entry codes to service personnel, etc.
Note:
A short buzz sound indicates when the relay has been activated
and the visitor can now open the door.
See
Programming
section
L. Global Keyless Entry
for a description of the Global Keyless Entry feature.
Operation Description
Touch Tone Command
*Activate door strike relay
Q Q
* Continuously activate (latch) door strike relay
Q
1
*Continuously de-activate (unlatch) door strike relay
Q
0
* Toggle relay from last position
Q
#
Answer or disconnect an entry phone call
#
Monitor entry phone 1
#1
Monitor entry phone 2
#2
Monitor entry phone 3
#3
Monitor entry phone 4
#4
CAUTION: Some strikes are designed for intermittent operation only. The latch and toggle commands
should NOT be used with these intermittent strikes, or damage to the strike may occur. Only use the latch
and toggle commands with strikes designed for continuous operation.
* Notes: 1.
The activate door strike relay column is shown with the default ”
” as the door strike activation code.
To change the door strike activation code, see
Programming
section
H. Door Strike Activation Code
.
Note that the remaining three operation commcands (
Q
1
,
Q
0
, and
Q
#
)
are not programmable
2.
The latch commands can be disabled (see
Programming
section
B
).
3 .
The “toggle relay from last position” command (“
Q
#
”) will NOT be accepted when a house phone is
connected to an entry phone. The toggle command will be accepted if a house phone goes off-hook
and dials the toggle relay command without calling the entry phone (“
#1
Q
#
” to toggle door strike relay 1
from it’s current position for example).
G. Dialing “#” on Cable Company Provided Phone Lines
On some cable company provided phone lines, when the house phones go off-hook and dial “#” as the first digit
of a command to monitor an entry phone or control a door strike relay, the cable company provided line will
produce a short break in the line and this short break will cause the
C-2000B
to not accept the command. This
problem can be corrected by enabling the “# Conflict Mode”
(1#67
, see
Programming
section
M
). When the “#
Conflict Mode” is enabled and “#” is the first digit dialed by a house phone, the
C-2000B
immediately switches
the house phone to an artificial line, which allows the monitor or relay control command to work properly. The “#
Conflict Mode” can be disabled by entering “
0#67
” in programming.
