15
1
1
1
2
3
2
2
Legs are packed in cardboard top pack.
Note:
Legs should be installed near to where
appliance is to be used, as they are
not secure for long transit.
Note:
It is strongly recommended
that a pallet or lift jack be used rather than tilting.
Raise unit about a foot. Unscrew temporary legs from
couplings on all four corners
.
4
Lower range gently to keep any undue strain from
legs and internal mounting hardware.
3
Screw legs into couplings on all four corners.
Leg Installation
14
NOTICE
DO NOT
use the handle or oven door
to lift the oven. Remove door before
installation to ensure that it is not used
to lift the unit.
DO NOT
lift or carry the
door by the handle.
Removing the door must be done by
your dealer, a qualified licensed plumber,
or certified gas installer.
Door Removal
1
Open door completely. Place pins, supplied with unit, in
pin hole. For personal safety, ONLY use pins
supplied with the unit.
2
2
1
2
Remove hinge trim screws. Take off hinge trim.
3
Close until pins stop door.
4
Lift door up and out.
Installation
Kickplate Installation
The kickplate bracket and scews (2) are located with the anti-
tip bracket. Without removing the kickplate and using a short
screw driver, install the bracket on the inside of the kickplate
using the two screws provided.
