19
1
2
1
x4
Install island trim.
2
3
Burner caps are packed in cardboard top pack with the grates.
Place burner on top of range. Place burner grate on top of burner
cap and grate support.
3/8”
3/8
”
(0.95 cm)
(0.9
5 c
m)
3/8”
(0.95 cm)
4
Check that unit is level side to side
and front to back. The side trim must be 3/8” (0.95 cm)
above countertop. If unit is not level repeat Steps 5-7
of “Leveling/Adjustments/Alignment” section.
Slide range into place. Be sure
anit-tip bracket slides into the anit-tip opening.
Final Installation
Note:
Standoff spacers can only
be removed if range is installed
against a
NON-COMBUSTIBLE
wall. Please see the backguard
install guide for instructions on
how to remove the standoff
spacers.
Standoff Spacer Removal
Note:
Standoff spacers can only be removed if range is installed against a
NON-COMBUSTIBLE
wall.
DANGER
FIRE HAZARD
Backguards come standard with
standoff spacers which provide
a barrier between back of range
and rear wall. These must be in place for
adequate ventilation. The standoff
spacers may only be removed if range is
installed against a non-combustible wall.
18
1
Note:
Refer to electrical and gas
requirements section for proper
installation information.
4
Attach bracket with
mounting hardware provided.
Connect gas and electrical. Before placing appliance in operation,
always check for gas leaks. This must be performed by your
dealer, a qualified licensed plumber, or gas service company.
Connecting Gas & Electric
DANGER
GAS LEAK HAZARD
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
Anti-tip Device Installation
(cont.)
