Vig410P Motherboard Manual
30
Internal Speaker
The Internal Speaker, located at SP1, can be used to provide audible indications for
various beep codes. See the table on the right for pin definitions. Refer to the layout
below for the locations of the Internal Buzzer (SP1).
Figure 11:
Internal Speaker
Power LED/Speaker
On the JD1 header, pins 1~3 are used for power LED indication, and pins 4-7 are for
the speaker. See the tables on the right for pin definitions. If you wish to use the
onboard speaker, you should close pins 6~7 with a jumper. Connect a cable to pins
4~7 of JD1 to use an external speaker.
A-
Internal Speaker (Buzzer)
B-
Power LED/Speaker
Figure 12:
Power LED/Speaker connection
Note:
The speaker connector pins are for use with an external speaker. If you wish to
use the onboard speaker, you should close pins 6.7 with a jumper.
