Vig410P Motherboard Manual
22
Motherboard Jumper Settings
Clear CMOS (JBT1)
JBT1 is used to clear CMOS. Instead of pins this “jumper” consists of contact pads to
prevent the accidental clearing of CMOS. To clear CMOS, use a metal object such as a
small screwdriver to touch both pads at the same time to short the connection. Always
remove the AC power cord from the system before clearing CMOS.
Note:
For an ATX power supply, you must completely shut down the system, remove
the AC power cord and then short JBT1 to clear CMOS.
GLAN Enable/Disable Jumper (JPL1/JPL2)
JPL1/JPL2 enables or disables the GLAN Port1/GLAN Port2 on the Motherboard. The default
setting is
Enabled.
A. GLAN Port 1 Enable
B. GLAN Port 2 Enable
Figure 5:
GLAN Jumper Location
Table 7:
GLAN Jumper
Function/Mode
Jumper Setting
Configuration
(Default)
Enable
1-2
Enables onboard LAN controller, this may also
be controlled via additional BIOS setting.
Disable
2-3
Disables onboard LAN controller. If set to
disabled this may not be enabled via
additional BIOS setting.
