Vigilant MX1-Au, Operator'S Manual

Page: 57 / 182

Document: LT0439 Vigilant MX1-Au Operator Manual
Issue 1.73 23 October 2018 Page 5-1
This chapter describes using the front panel to view the status of zones
and points.
The various states that zones and points can have are described on
pages 1-15 and 1-12 respectively.
Note; some points may be recallable and appear to be in various
“normal” states, but cannot have commands performed upon them. This
may be due to the configuration settings used in a particular
MX1
installation, or that the points are for display-only purposes.
Equipment Points are listed on page 12-8.
Refer to the page number listed in this table for information on a specific
topic.
Topic See Page
Recall Menu Options 5-2
Recalling Off-Normal Points and Zones 5-3
Using the Zone Key to Recall Zones and Points 5-8
Chapter 5
Recalling Zone and Point Status
Introduction
In this Chapter