Vigilant
MX1-Au
Operator Manual
Document: LT0439
Page
23 October 2018
Issue 1.73
5-2
If the
MX1
display is not showing one of the base displays, i.e., Normal,
Off-Normal, Fault or the Alarm List, press and hold
CANCEL
until the
base display is reached.
Press
MENU
(or from the Alarm List press TECHMENU-F4) to see a set
of options:
|DISP TST
| RECALL
| HISTORY
Press MENU for more options | POWER
Fig 5-1 – Menu Options
Press
RECALL
F2
to select what to recall.
Fig 5-2 – Recalls Menu
Press:
POINTS
F1
to show the off-normal points recall options
ZONES
F2
to show the off-normal zones recall options
ALL PTS
F3
to show the state of all points
ALL ZNS
F4
to show the state of all zones.
In the subsequent point or zone displays, pressing
MENU
F4
or
MENU
displays a menu of commands that may be applied to the zone or point.
These are described in Chapter 6,
”Zone and Point Functions”.
Note
: some points may be programmed to be excluded from off-normal
or fault displays because they are not used in a particular
MX1
installation. Therefore, these will never appear in the Faults list or the
Off-Normal Points list. However, they may be programmed to appear in
the All Points list, and may show a state other than Normal. Some points
may be programmed to never be displayed, and these points will not
appear in any of the lists.
Recall Menu Options
Select what to recall
|
POINTS
|
ZONES
|
ALL PTS
|
ALL ZNS
