Vigilant
MX1-Au
Operator Manual
Document: LT0439
Page
23 October 2018
Issue 1.73
5-8
“002” is the number of the zone. “Std Detection G1” is the name of the
operating profile that has been programmed for the zone.
“Factory” is the description given to the zone to associate it with its
general physical location.
“Normal” indicates that no alarms, faults or other conditions are current
for this zone.
Press
NEXT
F3
to navigate forward to the next zone, and
PREV
F2
to
move back to the previous zone.
From the All Zones status display, you can directly enter the number of a
new zone to be displayed. Press
ENTER
F1
to show the zone number
entry display:
Enter zone number
:
Fig 5-14 – Entering a Zone Number
Enter the number of the zone to be viewed using the numeric keypad,
followed by
OK
.
To recall a zone, press
ZONE
from the base display or Alarm List.
Enter the required zone number and press the
OK
key. This will show
the recall status display for that zone. See chapter 6 for the commands
available on a zone status display.
To recall a point, press
ZONE
twice from the base display or Alarm List.
Enter the required point number and press the
OK
key. This will show
the recall status display for that point. See chapter 6 for the commands
available on a point status display.
E
n
t
e
r
i
n
g
Z
o
n
e
n
u
m
b
e
r
s
Using the Zone Key to Recall Zones and Points
Zones
Points
