36
Important:
The electrical installation is protected from
dust and grease at both ends with shrink-wrap film. Do
not remove this film until ready to actually connect the
ends to the modules.
If the film is damaged or removed, protect both terminals
with electrical tape as shown in the figures.
Connection to Satellite Module
The Vigia electrical connection provides the wires that relay the digital information to the existing satellite
module in the vehicle (please see diagram above.). Specific connection instructions should be requested
to the telematics systems provider.
4 -
TIRE PRESSURE CALIBRATION
Before tire pressure calibration, make sure that:
1. Tires are “cold” (ambient temperature at least 4 hours
after rolling).
2. Air tank pressure is at least 10 PSI higher than the
maximum desired tire pressure. To assure this is the
case, proceed as follows:
a. Drain air tank completely.
b. Connect the hose end from the air filter to a
gauge.
c. Start the engine and verify in the connected
gauge that the compressor cut-off pressure
is a minimum of 10 PSI higher than the
maximum desired tire pressure. If that is not
the case, increase the pressure using the
compressor's governor.
d. After this procedure, disconnect the gauge.
