VZ-CMK01
Installation Instructions
Visit the ViewZ website at http://www.viewzusa.com
Page 7
Mounting Hardware
Selecting the Mounting Hardware
Insert a small straw or toothpick into the threaded
inserts found on the back of the flat panel.
®
Use a pencil to mark the depth of the threaded insert
on the small straw or toothpick.
¯
Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
°
Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
±
Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use this
screw. The screw length must not bypass the mark.
²
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Does your flat panel have:
●
Recessed mounting points?
●
Uneven mounting points?
●
A curved back?
●
Any obstruction near the mounting point?
If
Yes
, you must install Universal Spacers.
Proceed to the “Universal Spacer Installation”
section.
If No, skip to the “VZ-AP200 Adapter Plate
Installation” section.
Attaching the VZ-CMK01A
¯
Use the M3 Allen wrench to tighten the M6 x 6mm set
screw located on the side of the VZ-CMK01A mount.
M3 Allen Wrench
M6 x 6mm Set Screw
Proceed to the “Mounting Hardware” section.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
