VZ-CMK01
Installation Instructions
Visit the ViewZ website at http://www.viewzusa.com
Page 11
VZ-CMK01B Installation Instructions
Securing the VZ-CMK01B
Introduction
VZ-CMK01B
These 6 x 6 in. adapter plate have a 1.5 in. NPT threaded
pipe coupling. They can be used with any standard 1.5
in. NPT pipe or with one of our 1.5 inch adjustable-height
suspension adapters (VZ-CMK-P3) for drop distances of
more than 3.8 ft. The VZ-CMK01B has a welded coupler
with a through hole.
Installing the VZ-CMK01B
The ceiling should be capable of supporting at
least five (5) times the weight of the product
that will be used with this accessory. If the
surface cannot support this weight, it must be
reinforced. Proper installation procedure by
qualified personnel as outlined in the installation
instructions must be adhered to. Failure to do so
could result in serious personal injury.
Step 1.
Install the VZ-CMK01B to the ceiling structure using the four corner
mounting holes, according to commercial standards (Figure 1).
Step 2.
Use (commercially available) suitable hardware depending on the
installation requirements
VZ-CMK01B
Bolt
Washer
Ceiling
Washer
Nut
Commercially
Available
Hardware
Locking
M6 x 12mm
Phillips Screw
1) To attach the 1.5” NPT pipe to the VZ-CMK01B,
loosen the pre-installed
M6 x 12mm locking screw and thread your pipe or
suspension adapter
into the coupler.
Be sure to turn the pipe five (5) complete turns
before releasing it.
2) Use a Phillips screw driver to tighten down the pre-
installed M6 x 12mm locking screw to secure the
1.5" NPT pipe to the VZ-CMK01B.
