background image

VZ-CMK01

Page 2 

Visit the ViewZ website at http://www.viewzusa.com

 

Installation Instructions

Contact ViewZ with any questions: 
(888) 99-ViewZ
[email protected]

Contents

Warning Statements

Weight Limit

Maximum Flat Panel Weight: 

50 lbs.

THE CEILING STRUCTURE MUST BE CAPABLE OF 
SUPPORTING AT LEAST FIVE TIMES THE WEIGHT OF 
THE FLAT PANEL. IF NOT, THE CEILING STRUCTURE 
MUST BE REINFORCED. 

 PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS MUST BE READ AND 

COMPLETELY UNDERSTOOD. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION 

FOR FUTURE REFERENCE.

 PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN MUST BE FOLLOWED, AS OUTLINED 

IN THESE INSTALLATION INSTRUCTIONS. FAILURE TO DO SO COULD RESULT IN PROPERTY DAMAGE, SERIOUS 

PERSONAL INJURY, OR EVEN DEATH.

 SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE 

PROPER SAFETY EQUIPMENT AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.

 VIEWZ DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY VIEWZ PRODUCT FOR PURPOSES 

OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED ATTACHMENTS 

OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS, ACTIONS OR 

CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER RELATING TO 

ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.

 

 At least two qualified people should perform the assembly procedure. Personal injury and/or property damage can result 

from dropping or mishandling the projector.

 

 If mounting to wall studs or ceiling studs, make sure that the mounting screws are anchored into the center of the wall studs 

or ceiling studs. Use of an edge-to-edge stud finder is recommended.

 

 Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there 

 

are no electrical wires in wall. Cutting or drilling into an electrical line may cause serious personal injury.

 

 Make sure there are no water or natural gas lines inside the wall where the mount is to be located. Cutting or drilling into a 

water or gas line may cause severe property damage or personal injury.

 

 This product is intended for indoor use only. Use of this product outdoors could lead to product failure and/or serious 

personal injury.

 

 Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of 

impact.

Weight Limit. .................................................................................................................................................................... 2

Warning Statements. ....................................................................................................................................................... 2

Installation Tools. ............................................................................................................................................................. 3

Parts List.......................................................................................................................................................................... 3

Mounting Hardware.

 ........................................................................................................................................................ 4

Features. ......................................................................................................................................................................... 5

Installing the VZ-CMK01A Mount.

 ................................................................................................................................... 6

Introduction.

 .............................................................................................................................................................. 6

Attaching the VZ-CMK01A.

 ............................................................................................................................................. 6

Mounting Hardware.

 ........................................................................................................................................................ 7

Selecting the Mounting Hardware.

 ............................................................................................................................ 7

Universal Spacer Installation. ................................................................................................................................... 8

VZ-AP200 Adapter Plate Installation.

 ........................................................................................................................ 8

Attaching the Flat Panel to the VZ-CMK01A Mount.

 ....................................................................................................... 9

Adjusting the Mount Tension.

 ........................................................................................................................................ 10

Technical Specifications.

 ............................................................................................................................................... 10

VZ-CMK01B Instructions.

 ...............................................................................................................................................11 

Warranty.

 ....................................................................................................................................................................... 12

Disclaimer. ..................................................................................................................................................................... 12

Summary of Contents for VZ-CMK01













Reviews: