ViewSonic VS13518-1W, Service Manual

Page: 65 / 99

4. After the OSD turns off, it will not show on again before next timing change, input
change or power off.
5. Resolution Notice function should be disabled when push button [2] under
Resolution Notice OSD
6. The “1440x900” will be replaced by actual panel resolution.
5.3.5 0-Touch™ Function Actions
1. Execute Auto Image Adjust when new mode detected, and save the settings to
buffer for further use
2. It should be reset by Memory Recall function
(Should not reset by power off, power unplug and others)
5.3.6 OSD Auto Save
The OSD shall save new settings when it is turned off by the user or when it times out.
There shall not be a separate save
5.3.7 Out of range
While non-defined timing is detected, following OSD message will keeps showing on,
1. If the timing is over spec (Fh, Fv or dot clock), the image shall be blanking, and OSD
background shall be non-transparent.
2. If the timing is inspect but not defined, the image shall be non-blanking.
5.3.8 No signal
While no signal is detected for D-Sub and DVI, the following OSD message shall shows
on 3 seconds then go in to power saving.
OSD Background = Non-transparent
Image = Blanking
5.4 EDID (Rewrite EDID data to EEPROM)
I
f we need to rewrite the EEPROM data, please confirm the following steps.
1. Plug in VGA Cable; we can rewrite the EDID data to EEPROM by using “EDID Rewrite”
program.
Confidential - Do Not Copy
V
X2450W/WM
-
LED-1
ViewSonic Corporation
64