ViewSonic PJL6243, User Manual

Page: 23 / 177

17 ViewSonic PJL6243
17
Connecting the AC Power Cord
This projector uses nominal input voltages of
100-240 V AC and it automatically selects the
correct input voltage. It is designed to work with
single-phase power systems having a grounded
neutral conductor. To reduce the risk of electrical
shock, do not plug into any other type of power
system.
If you are not sure of the type of power being
supplied, consult your authorized dealer or
service center.
Connect the projector with all peripheral
equipment before turning the projector on.

Note :
Unplug the AC power cord when the projector is not in use. When this projector is connected
to an outlet with the AC power cord, it is in Stand-by mode and consumes a little electric power.
Connect the AC power cord
(supplied) to the projector.
To the AC outlet.
(200 - 240 V AC)
To power cord
connector on your
projector.
Projector side AC outlet side
To the AC outlet.
(120 V AC)
For the U .S .A . and Canada
To the AC outlet.
(200 - 240 V AC)
For Continental Europe
Ground
For the U.K.
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.


Ground
The AC outlet must be near this equipment
and must be easily accessible.
CAUTION
Installation
Before using the AC Power Cord, attach the ferrite core (supplied) as shown below. (See below for
mounting location.)
The Power Cord with ferrite core must be used for RF interference suppression.
0.39" (10 mm)
AC Power Cord
Ferrite Core
Keep closing until it makes
a clicking sound.
Using the Ferrite Core