ViewSonic PJD6250L, User Manual

Page: 49 / 87

38
CEC
This projector supports CEC (Consumer Electronics Control) function for synchro-
nized power on/off operation via HDMI connection. That is, if a device that also sup-
ports CEC function is connected to the HDMI input of the projector, when the
projector’s power is turned off, the power of the connected device will also be turned
off automatically. When the power of the connected device is turned on, the projector’s
power will be turned on automatically.
Note
• When connected to the HDMI input of the projector via an HDMI cable, and its CEC
function is turned on.
• Depending on the connected device, the CEC function may not work.
• The function can't be enabled when Active VGA out/Active Audio out function is
disabled.
Direct Power On
Selecting On the projector will turn on automatically after the power cord has been
connected and power has been applied.
Auto Power Off
Power Saving
The projector lowers the projector power if no input source is detected after 5 minutes
to prevent unnecessary waste of lamp life. You can further decide if you would like the
projector to turn off automatically after a set period of time.
When
Disable is selected, the projector power will be reduced to 30% after no signal
is detected for 5 minutes.
If you select
10 min , 20 min or 30 min , the projecter power will be reduced to 30%
after no signal is detected for 5 minutes. And when 10 min , 20 min or 30 min is up,
the projector will turn off automatically.
Sleep Timer
This function allows the projector to turn off automatically after a set period of time to
prevent unnecessary waste of lamp life.
Smart Restart
It takes some time to initate this function. Make sure the projector has been turned on
for more than 4 minutes. If the projector is resumed by using the Smart Restart fea-
ture, this function can be executed immediately.
Quick Power Off
• Enable: Quick power on function speeds up the cooling process when turning off
the projector.
• Disable: Turn off with cooling procedure.
Note
• When Disable is selected, the Smart Restart function will be automatically turned Off.