18
1. Take a Video cable and connect one end to the composite Video output socket of
the
Video source device.
2. Connect the other end of the Video cable to the
VIDEO
socket on the projector.
Important
• If the selected video image is not displayed after the projector is turned on and the
correct video source has been selected, check that the Video source device is turned on
and operating correctly. Also check that the signal cables have been connected
correctly.
• You need only connect to this device using a composite Video connection if Component
Video and S-Video inputs are unavailable for use. See
for details.
Playing sound through the projector
You can make use of the projector (mixed mono) speaker in your presentations, and
also connect separate amplified speakers to the
AUDIO OUT
socket of the projector.
If you have a separate sound system, you will most likely want to connect the audio
output of your Video source device to that sound system, instead of to the mono audio
projector.
You can also use a microphone to output the sound through the projector speaker
when the
SYSTEM SETTING: ADVANCED
>
Audio Settings
>
Audio In 2
menu is
set to
Microphone
"Adjusting the Audio In 2 setting" on page 51
for details.
Once connected, the audio can be controlled by the projector On-Screen Display
(OSD) menus. See
"Adjusting the sound" on page 50
for details.
About the microphone input
• If you wish to use a microphone, connect a 3.5 mini jack cable microphone to the
projector.
• There are two ways to adjust microphone volumes.
• Directly set microphone volume levels in the
SYSTEM SETTING: ADVANCED
> Audio Settings > Microphone Volume
menu.
• Set projector volume levels in the
SYSTEM SETTING: ADVANCED > Audio
Settings > Audio Volume
menu, or press Volume keys (+, -) on the remote
control. (The projector volume setting will affect the microphone volume.)
• To make the microphone input available when the projector is in standby mode, turn
on the
SYSTEM SETTING: ADVANCED > Audio Settings >
Active Audio out
menu.
• If the microphone is not working, check the volume setting and cable connection.
• You might get feedback noise from the microphone when you are too close to the
speaker of the projector. Move the microphone away from the speaker of the
projector. The greater volume you require, the greater distance you need to be
away from the Speaker to prevent the noise.
Summary of Contents for PJD6250L
Page 80: ...69 IR control table System Code 83F4 Format NEC ...
Page 87: ......
