VIETA VH-IS150SL, User Manual

Page: 20 / 32

iPad/iPod/iPhone Speaker
20
To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the apparatus is
connected properly.
- Ensure that there is power at the AC outlet.
- Press ON/OFF button to turn the unit on.
Remote control does not work
- Before you press any function button, first select
the correct source.
- Reduce the distance between the remote control
and the unit.
- Insert the battery with its polarities (+/-) aligned as
indicated.
- Replace the battery.
- Aim the remote control directly at the ensor on the
front of the unit.
No Response From the Unit
- Disconnect and reconnect the AC power plug, then
turn on the unit again.
Poor radio reception
- Increase the distance between the unit and your TV
or VCR.
- Fully extend the FM antenna.
- Connect an outdoor FM antenna instead.
Timer does not work
- Set the clock correctly.
- Switch on the timer.
Clock/timer setting erased
- Power has been interrupted or the power cord has
been disconnected.
- Reset the clock/timer.
Using iPhone to play music
- While the iPhone is playing the music throught the
docking, there may be a chance that the iPhone
may not be under a good receiption mode to get the
incoming call signal.
Troubleshooting
General
Power Requirements AC 110-220V ~ 50Hz
Power Consumption 25W
Output Power 5W x 2
Total Harmonic Distortion 1%(1kHz, 1W)
Audio Input Sensitivity/Impedance 500mV/47kΩ
Frequency Response 40Hz - 20kHz(+/-3dB)
Tuning Range 76 - 108.0MHz
Unit Dimensions (W x H x D) 198 x 89 x 198mm
Speaker
Front
Impedance 6Ω
Rate Power 5W
Remote
Distance 6m
Angle 30º
Standard Accessories
Remote Control x 1
Owner’s Manual x 1

Design and specifications are subject to change without notice.
Specifications