Viessmann VITOPURE S5-D, Manual Book

Page: 4 / 16

4
DESKRIPSI PRODUK
Perangkat ini dipasang setelah meteran air dan setelah perangkat pre filter, dengan sumber air dari air PAM, perangkat ini
melakukan saringan dengan meninggalkan sedimen, karat, suspensi padat, dan mikroorganisme yang terkandung dalam
air. Dalam jangka waktu tertentu, filter atau saringan perlu diganti.
Vitopure S5-D , S5-T , S5-Q Non Electric Central Purifier
Vitopure S5-D , S5-T , S5-Q Non Electric Central Purifier
13
NOTE : NOTE :
FIRST RUN & MAINTENANCE
First Run Replace filter element
Check tightness
After installation, slowly turn on the valve on the main
water supply line.
Inspect all pipe connections involved
in the installation process for water leakage..
Initial use and start-up
When filter element reaches the end of its service life,
it will be replaced with a new one in a timely manner.
After the device stops working for a certain period, an
additional cleaning operation should be performed before
reuse to ensure the quality of the produced water. If the water
usage increases sharply (by comparing with normal water
usage), it is required to shorten cleaning cycle and increase
cleaning frequency.
Turn off the main water inlet valve.
Turn on any faucet of the cold water pipe located at the
downstream of water purifier pipe, release the pressure
of water purifier, and then turn off the faucet.
Unscrew the filter bottle from the device clockwise.
Replace filter bottle.
Turn on the faucet at the downstream of the device pipe.
Turn on main water inlet valve.
Turn off the faucet after it is found that the water outlet of
thefaucet at the downstream of the device pipe is stable.
Inspect whether there is water leakage on the thread of
filterbottle and tighten if necessary.
When the device is used for the first time, please check
all connecting fittings to make sure there is no water
leakage.
Slowly turn on the cleaning knob and check whether
thedrainage goes smoothly.
Drain water for 10 minutes before normal use.
ID
EN