Viessmann Vitopure S4-RO-800G, Manual Book

Page: 21 / 24

21 4
DESKRIPSI PRODUK
DATA TEKNIS
Perangkat ini dipasang setelah meteran air dan dapat melakukan perawatan kemurniaan terhadap air PAM. Perangkat menggunakan
teknologi osmosis separation membrane . Dengan menggunakan pompa, air didorong melalui osmosis separation membrane untuk
menyaring zat berbahaya dalam air.
Vitopure S4-RO- U Drinking Water Purifier
Vitopure S4-RO-U Drinking Water Purifier
Produk model : Vitopure S4-RO-U
Air masukan : Air PAM
Filter : PP fiber
Coconute shell activated carbon
Compressed activated carbon
acticated carbon with scale inhibitor
RO membrane
Compressed activated carbon
Note :
Note :
FIRST RUN
Replacement of filter element
Check Tightness
Install Power Adapter
Operation indicator
Upon the completion of installation, slowly turn on the main
water source switch and 3-way ball valve switch. Check the
connections of 3-way ball valve, PE pipes at each inlet and
outlet of water purifier, connection of the quick connector
on the faucet screw one by one in the order of water inlet
and outlet.
Make sure the above connections are installed in a correct
manner without water leakage. Before water purifier is
powered, make sure that the circuit system is kept dry.
The standard power adapter is the default device
providing power to the device.
Insert the round plug at the output end of the
power adapter into the power input hole at the rear
of the device.
Connect the power adapter to a power outlet.
When the device is used for the first time, please
check all connecting fittings to make sure there is
no water leakage.
Slowly turn on the cleaning knob and see whether
the drainage goes smoothly.
After installation, connect to power supply, touch
the touch switch on the front panel to turn on the
operation indicator and turn on water
faucet outlet switch.
Drain water for 10 minutes before normal use.
Gently touch the touch switch on the front
panel to turn on the operation indicator and
turn on water faucet outlet switch
Initial use and start-up
Replace filter element
Remove the filter element
Re-install the filter element
The device is used to remove sand, rust, suspended solids,
microorganisms, residual chlorine, abnormal colors and odors,
other sediments contained in water. If the water source itself
contains viscous sediment, such as silt and clay etc., it is
necessary to replace the filter on a regularly basis.
Turn off 3-way ball valve of the device, turn on water purification
faucet, release the pressure of water purifier and then turn off
the water purification faucet.
Turn off the power and pull out the power adapter from power
outlet.
Open the front lid of the device. Hold the upper cover
of the filter casing and rotate it counterclockwise until the
upper cover of casing is unscrewed.
After maintenance and replacement of the filter element
are completed, rotate the filter element back and rotate the
upper end of the filter casing clockwise until it is tightened.
Upon the completion of cleaning or replacement, turn on
water outlet switch and check whether there is water leakage
in each connection.
Before the use of new filter element for the first time,
turn on water faucet and make water flow 10 minutes.
It is necessary to replace filter element, please purchase
the original one.
ID
EN
Kapasitas air : 2,2 liter / menit
Tekanan kerja : 1 - 6,5 Bar
Pipa air masuk / keluar : DN8
Pipa bilas : DN8
Temperatur air masuk : 1- 39 ºC
Daya masukan : AC100 - 240V, 50/60Hz
Daya keluaran : DC6V-1000mA