11
5813 312 - 01
Vitocell 300-W/V, EVIA/EVIB Installation, Operating and Service
Installation
119 USG (450 L) Tank Installation
CAUTION
The thermal insulation must not come in contact with
open flames. Exercise extreme caution when welding
and soldering.
1. Fit the thermal insulation blanket below the tank prior
to the installation of the tank itself.
Setting the DHW tank and fitting the thermal insulation
mat at the bottom
All necessary parts for enclosure assembly are packaged
in a separate carton.
1. Guide the thermometer sensor through the cover
strip and insert the thermometer.
Note:
The cover strip is held in its vertical position
by the straight capillaries. This is necessary
for the rest of the installation.
2. Insert the upper thermometer sensor as far as it
will go into the hole in the tank cap.
3. Use clips to secure the thermometer sensor
against being pulled out.
4. Route the bottom thermometer sensor capillaries
to the back of the tank body.
5. Screw the nuts onto the threaded studs. Do not
tighten.
6. Push the clamps onto the threaded studs and
align.
7. Tighten the nuts.
8. Depending on where the sensor is being fitted:
Insert the thermometer sensors and tank
temperature sensors into clamp
A
as far as they
will
go.
Note:
H
Never wrap insulating tape around the
sensors.
H
When the thermal insulation is being
fitted, the tank temperature sensor leads
are routed outwards through the apertures
(slots) in the rear cover strip.
H
The tank includes one (1) thermometer.
Fitting the thermometer sensor and tank temperature sensor
