66550060-EN - V1.0 - 06/02/14
6
IPVK - IPVKC Series IP videokit
IPVK-IPVKC - Installation handbook
Connect the door panel as shown in “Power supply & connec-
tion” on page 9
Connect the videointercom as shown in “power supply & con-
nection” on page 25
Power up the system and execute the auto search procedure
from the videointercom as shown in section “Search” on page
41
The video door entry system is
ready to use
Verify that the preliminary ethernet LAN requirements are
satisfie .
See “LAN requirements for installation” on page 6
OPERATING THE VIDEOKIT
Open any internet browser then enter the IP address of the
videointercom/door panel
Navigate to the LAN settings page
see sections “Network parameters changes“ for Art.KRV98/96
on page 29 and for Art.4503 on page 14
Save the settings as required then wait for the unit to restart
The video door entry system is
now ready
Connect a PC (laptop or fi ed) to the existing LAN as shown
in section “Art
. KR
V98-KRV96 Hardware setup” on page 26
and “Art
. 4503
Hardware setup” on page 11
CHANGING THE VIDEOINTERCOM/DOOR PANEL
LAN SETTINGS
LAN REQUIREMENTS FOR INSTALLATION
The IP devices included in the kit can work when directly connected together but to use the services that require an internet con-
nection it is better to connect the devices through an existing ethernet LAN.
The factory preset static IP addresses are:
Speaker unit module
192.168.1.3
Videointercom 1 (one way and two way videokits)
192.168.1.4
Videointercom 2 (two way videokits)
192.168.1.5
Before connecting the devices to an existing network check that the network address range is the same as the devices and that the
devices IP addresses are not already in use.
If the device’s addresses are in use or the range of network addresses is different, proceed to the section “IP devices - setup
procedure” on page 7.
CONNECTION TO MAINS
The system must be installed according to IEE and building regulations, in particular we recommend to:
• Connect the system to the mains through a
double pole circuit breaker
which shall have contact separation of at least 3mm in
each pole and shall disconnect both poles simultaneously;
• The
double pole circuit breaker
shall be placed for easy access and the switch shall remain readily operable.
ATTENTION
Fix the devices permanently to the wall only after testing the system.
Operating the videokit
