Videotec ULISSE COMPACT, Instruction Manual

Page: 45 / 414

Instruc
tions manual - English - EN
43 MNVCUCZ_1511_EN
9.1.13 Washer Menu
The P&T offers the possibility to use a wiper and to
operate a pump to clean the glass.
To configure the Washer put the lens of the camera in
front of the nozzle of the Washer.
Save a preset (XY) that identifies this position; the
preset will be recalled by the pan & tilt when the
WASHER function is enabled.
Configure the following parameters:
1.
Enable
: Enabling the Washer function.
2. Nozzle Preset : Enter the preset number (XY)
corresponding to the nozzle.
3.
Wiper On Delay
: Select the time interval
between the pump and wiper.
4.
Washing Length
: Choose the duration of
brushing.
5.
Wiper Off Delay
: Choose the duration of
brushing without water.
WASHER
------------------------
1>ENABLE : N
2 NOZZLE PRESET : 1
3 WIPER-ON DELAY : 5
4 WASHING DURATION : 10
5 WIPER-OFF DELAY : 5
Fig. 81
The enabling of the Washer function
reserves the use of Relay 2 to the switching
on of the pump and does not allow the
association of Relay 2 with an alarm.
9.1.14 Default Menu
1.
Delete Setup
?: Resets all the parameters except
the Presets.
2.
Delete Preset
?: Deletes all previously stored
presets.
DEFAULT
------------------------
1>DELETE SETUP?
2 DELETE PRESET?
Fig. 82
The above mentioned operations cause the
loss of all previously stored data (i.g. Preset,
Patrol, Autopan, Home…).
9.1.15 Info Menu
The menu is used to check the configuration of the
device and the installed firmware version.
INFO
------------------------
Address: 1
Protocol : MACRO
RS485-1: 38400 N81 RX
RS485-2: 38400 N81 RIPET
FW: 0a (Apr 14 2009)
HW: 000-0000
Camera : 36x
PC: UC1PSSA000A
SN: 109032220029
Fig. 83