Videocon VT55A11, Owner'S Manual

Page: 8 / 14

Fault Diagnosis Chart
BEFORE CALLING VIDEOCON SERVICE CENTRE - CHECK THESE POINTS
There may be certain conditions when machine may not function properly & it may give the
Error Signal so check these point against the symptoms.
SYMPTOMS CHECK POINTS
1. Doesn’t run at all.
Check if there is power failure.
Check if the power fuse has blown.
Check if the power plug is plugged in thoroughly.
Check if the power switch has been pressed.
Check if the tub has been filled with the prescribed
quantity of water
(Has the water tap been turned on).
Check if the START/HOLD switch has been pressed.
2. If there is no water supply
Check if you have forgotten to connect the water
hose & to turn on the tap.
Check if the water supply & water hose are frozen.
Check if the water supply has been cut-off.
Check if the connection of water supply hose is clogged
with dirt.
3. When power switch is
pressed ‘ON’ machine starts
any operation abruptly
This may be due to stored Memory of previous program.
Please refer to memory back-up on page 8.
NOTE :
“This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.”
Specification*
Page-10 Page-11
Usual Faults and Resolving Methods
1. Water is not
supplied after
pressing START/
HOLD switch.
Above set of LEDs starts blinking with
buzzer for 10 seconds. After 10 seconds
buzzer stops but LEDs blink continuously
till machine lid is once opened & closed
once or till water level in tub reaches the
set level. As soon as water level is reached
or lid is open & closed, machine restarts
with its normal operation.
PROGRAM
PROCESS
Have connected
water supply hose &
did you open water
tap ?
Water supply may not
be there.
Water supply hose port
filter may be clogged
with dust. (Refer to
Cleaning of water
supply Hose port on
page 16)
Did you press START/
HOLD switch ?
Ensure proper water
supply.
NORMAL
WASH
RINSE
ERROR
SIGNAL CHECK POINT
SPIN
Lid may be open.
Close the lid, then only
machine will resume
the rest of cycle.
2. Rinse/Spin does
not start though
water is draind
STRONG WASH
RINSE
SPIN
Above set of LEDs starts blinking with
buzzer for 10 seconds. After 10 seconds
buzzer stops but LEDs blink continue
blinking till the lid is closed. As soon as
lid is closed machine restarts with its
normal operation.
PROGRAM
PROCESS