Videocon VT55A11, Owner'S Manual

Page: 9 / 14

3. Water is not
drained after
opening of
drain valve
Above set of LEDs starts blinking with
buzzer for 10 seconds, the drain valve is
closed. After 10 seconds buzzer stops but
LEDs continue blinking till machine lid is
once open & closed once. As soon as lid
is closed machine restarts with its normal
operation.
Drain hose may be
abnormal is it lowered ?
Water may be frozen in
it & It may be clogged.
It may be kinked.
Part of drain hose may
be positioned 165 mm or
more higher than floor
level.
Extension hose may be
longer than 3 m.
Hose bore may be too
small.
* Ensure proper drain
system.
WOOL
WASH
RINSE
SPIN
Clothes in the tub may
be gathered on one
side.
Machine may be
4. Midway during
spinning, the
operation
suddenly
SAREE
WASH
RINSE
PROGRAM
PROCESS
wobbling or the floor
changes to
SPIN
may be inclined.
When laundry is
unbalanced during
spin drying automatic
balancing is done by
machine for 2 times by
rinsing & again 3rd
time if imblance
occurs machine gives
the error signal then
rinsing.
Above set of LEDs starts blinking with
buzzer for 10 seconds. After 10 seconds
buzzer stops but LEDs continue blinking
machine will resume the operation, open
PROGRAM
PROCESS
the lid & clothes are evenly distributed then
distribute clothes
lid is closed.
evenly in the tub.
ERROR SIGNAL CHECK POINT
Page-12
Usual Faults and Resolving Methods
Page-13
Safety Precaution
Do not use the Washing Machine to wash items other
than Clothes, Blankets, Curtains, Towels and things
alike.
Never disassemble, repair or remodel this
washing machine.
This can cause fire or
irregular action that
results in injury.
Consult your dealer for repair.
Do not damage the power cord and power plug.
(Do not damage, modify, excessively bend, twist, pull,
or bundle the power cord, do not put the power cord
and plug close to a heating appliance, do not put any-
thing heavy on power cord and plug.) If the power
cord cord and plug is damaged, there is a risk of
electric shock, short circuit or fire.
Consult with your dealer about repair of the cord
and plug.
Never touch laundry with your hand
during the spin cycle untill the tub has
completely stopped spinning.
If you touch the laundry, even if the tub
is rotating slowly, there is a danger of
injury if your hand becomes entangled
with the laundry. Pay particular attention
to protecting children from such injury.
Do not install the washing machine
in a humid place such as a bathroom
or in a place exposed to the weather.
There is a risk of electric shock, fire,
breakdowns, or deformation.
When you are cleaning your
washing
machine, do not
apply water directly to any part
of the washing machine.
It will cause short circuit and
electric shock.
Children may fall into the tub and
get drowned. Do not leave the
washing machine with lid open
and water remaining inside.
Do not allow your child peer over the
wash tub. Do not place a stool or simi-
lar objects near washing machine.
Do not place flammable
substances near the machine
such as kerosene, benzine,
paint thinner and alcohol. Do
not put clothing with such
substances in the tub.
There is a risk of explosion or fire.
Remove any dust which may accumulate around
the electric cord.
When dust has accumulated on and around the plug,
and the dust gets damp or wet, its insulation becomes
defective and may cause a fire.
Pull out the plug, and wipe off dampness with a dry
clean cloth.
If you are not going to use the washing machine for a
long period of time, pull the power plug out of the socket.
Do not put your hand or foot
under the washing machine
while
the machine is
operating.
There is a rotating mechanism
under the machine, so you
could be injured.
Always pull the power plug out
of the socket before doing any
cleaning or maintenance of
the washing machine.
Otherwise, you may suffer
electric shock or injury.
Do not use a plug socket and wiring equipment
for more than their capacity.
If you use socket or wiring for more than its rated
capacity by connecting multiple appliances, it can
cause fire due to overtheating.
Make sure to push the plug
completely into the socket.
If the plug is not completely pushed into
the socket, this will cause electric shock
and fire due to overheating.
Never use a damaged power plug
or cord
Do not pull out or push in the power
plug with a wet hand.
It will cause electric shock.