Victoria-05 Ltd.
14
In the Information Section one can supervise the
operation of the sensors, to check the operation mode,
etc.
Smoke Gases indicates the Chamber
Temperature.
Water Heater indicates the Water-heater
Water Temperature.
Indoor Temperature indicates the temperature
in the room.
Flow indicates the pressure, measured at the
air fan input. This is measured in Pa(pascals).
Fan Speed indicates the turns of the Smoke
Fan. This is measured in rpm.
Fan Power indicates the power, set for the
particular mode. This is measured in
percentage.
Date and time
Here one can switch among
three options.
The first one is “Switch the
Timer ON”. If set active, the
fireplace would automatically
transfer to “Timer” Mode.
The second one is “Delayed
Start”. To set this one active,
it is important that the
“Switch the Timer ON” shall
not be active. The delayed
start is an autonomous one-
time timer, which one can set
a particular date and hour on,
to start the fireplace.
Its
effect is a one-time individual
one!
The third option is
“Hour/ Date”.
There are 24 tick-boxes for the hours from 0 to 23. There are seven days from Monday to Sunday.
Say, we’d like to set the fireplace to start on Monday at 10am and to stop at 12 noon. To then restart at 5pm and to stop at 9
pm.
How shall we do this?
The hour tickboxes from 0 to 9 should be left empty (non-ticked).
Meaning that through the hours from 00:00 to 09:00 it will not operate.
The boxes 10 and 11 should be ticked.
Meaning that through the hours from 10:00 to 12:00 it will operate.
The tickboxes from 12 to 16 should be left empty (non-ticked).
Meaning that through the hours from 12:00 to 16:00 it will not operate.
The boxes 17 to 21 should be ticked.
Meaning that through the hours from 17:00 to 21:00 it will operate.
The hours from 22 to 23 should be left empty (non-ticked).
