8
SETUP & BASIC OPERATION
Essential Setup
1. Unpack the unit and remove all packaging materials.
2. Place the unit on a flat and level surface. The selected location should be stable and free from
vibration.
3.
Plug the power adaptor into the electrical outlet and connect other end to the back of the unit.
Press the Button on the upper right corner of the front panel. The display will light up in
amber background, and the playback mode will appear on the display.
When the unit is playing music, the playback message will appear on the display.
To Open Turntable Cover:
1. Lift the turntable cover all the way up until it stops.
2. Lower the cover slowly until the latch engages. If the latch
does not engage, pull the lower bar by hand.
3. The cover will now stay open.
To Close Turntable Cover:
1. Lift the cover all the way up until it stops.
2. The latch should disengage and you may now slowly lower the cover.
If the latch does not disengage, push out the lower bar by hand.
3. Make sure you hold the cover to avoid pinching your fingers as it closes.
Common playback control
● Press the PLAY/PAUSE button to pause / play the playback.
● Press the
or
button to skip to next or previous track.
● To search for a part of track: press and hold the
or
button and release it when the
part you want is found.
● Search for a folder, press the Item Up/Down buttons to choose the folder.
● Press the STOP/PAIR button to stop playing.
Note:
These controls do NOT always function in specified playback mode.
Repeat function
Press REPEAT button: ● one time, to repeat the current track.
● two times, to repeat the current folder.
● three times, to repeat all tracks of the disc.
● four times, to cancel the repeat function.
Note:
This feature functions in CD and USB mode.
Program function
This function enables you to set the playback of tracks into an ordered playlist.
1.
Press the STOP button; then p
ress the
PROG/MEMORY
Button to activate the program
feature. The display will show
“MEMORY”, “P01” and blinking “00”.
2. Press the
or
button to select your track.
3. Press the
PROG/MEMORY
button again to confirm.
4. Repeat the above steps to program other tracks.
5. After finished, press the
PLAY/PAUSE
button to start playback.
6. Press the
STOP
button once to stop.
7. Press the
STOP
button twice to erase the programmed track, and “MEMORY” will disappear
from the display.
Note
:
● This feature functions in CD and USB mode.
● This unit can program up to 20 tracks.
● Turning the power off or switching to other playback modes by turning the Function Knob will
automatically erase the programmed playlist.
4
.
5
.
