3 | VWG-50-Installation Manual
Ferrites supplied with the power supply and VWG MUST be installed according to
instructions. Failure to do so may void the FCC compliance of the VWG and wireless
controllers.
Only VWG-PS-DC and VWG-PS-AC power supply can be used with the VWG. The usage
of another non-approved power supply may void the FCC compliance of the VWG and
wireless controllers.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
T
RADEMARKS
Niagara, Niagara AX is a registered trademark of Tridium, Inc.
LON, LonWorks™ and LonTalk™ are registered trademarks of Echelon™ ™ Corporation.
BACnet™ is a registered trademark of ASHRAE.
O
VERVIEW
This document covers the mounting and wiring of the Viconics VWG-50 series product. It
assumes that you are an engineer, technician, or service person who is performing control
system installation. Instructions in this document apply to the following products:
Note:
Not covered in this document is the configuration appliance software required for
fully setup the gateway. This includes setting host IP address, passwords, database, and
other controller and network utilities. Refer to the document LIT-VWG-50-SETUP-Exx for
more information.
