10
•
Chapter 4 - Operation
XX159-07-00 Rev 1010 VN-301T Single-Channel Digital Video Server
Chapter 4 - Operation
About This Chapter
This chapter details power on, power off and configuration of the VN-301T server. For full programming and
operation information, refer to the ViconNet Software manual, XX113-0X (where X is a revision number
between 0 and 9). The following sections provide information as follows:
Powering-On the Server
guides the user through proper power on and boot procedures.
Powering-Off the Server
guides the user through proper shut down procedures.
Configuring the Server
guides the user through network, PTZ and alarm/audio setup.
Powering-On the Encoder
To power on the encoder:
1. Verify that the server is set up as detailed in Chapter 3
, Installation.
2. Connect the 24 VAC power supply to the VN-301T. The Power Indicator will illuminate solid red to
indicate the encoder is ON.
Powering-Off the Encoder
To power off the server:
With the encoder operational, disconnect the 24 VAC power supply. The power indicator will cease to
illuminate, indicating a power OFF condition.
Summary of Contents for VN-301T
Page 2: ......
Page 8: ......
Page 20: ...12 Chapter 4 Operation XX159 07 00 Rev 1010 VN 301T Single Channel Digital Video Server...
